Abstract
AbstractThe anionic polymerization of methyl methacrylate was performed in tetrahydrofuran (THF) at −78°C, using sec‐butyllithium/1,1‐diphenylethylene (DPE) as the initiation system. The effects of polymerization time and initiator concentration on the branching reaction were studied. High vacuum was used to prevent contamination during the polymerization. Gel permeation chromatography (GPC) was used to characterize the branching effect qualitatively. Experimental results indicated that the monomer conversion reached more than 98% in a polymerization time of 10 min. The branching reaction occurred after high monomer conversion, resulting in a tail of high molecular weight in the GPC trace. This branching effect, observed by GPC, increased with polymerization time. Rapid termination was thus probably required immediately after all of the monomer was consumed in the preparation of a well‐defined PMMA without a high‐molecular‐weight tail in this diphenylbutylllithium/THF/−78°C system. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2009
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.