Abstract
ABSTRACTManganese mineralisation in the Oakover Basin is associated with Mesoproterozoic extension, basin formation and deposition of the Manganese Group. The underlying basement architecture of the Oakover Basin (a local half-graben geometry), inherited from the Neoarchean rifting event, plays an important role on the distribution, style and timing of manganese deposits. Fault-hosted manganese deposits are dominant along the ‘active’ faulted eastern margin, whereas flat-lying sedimentary deposits are dominant along the western ‘passive’ margin reflecting differences in ore-forming processes. The large number of significant manganese deposits in the Oakover Basin, previously thought to reflect a spatial association with Carawine Dolomite, more likely reflects the restricted nature of the Mesoproterozoic basin and development of a large reservoir of Mn2+ and Fe2+ in an anoxic zone of a stratified basin. Low O2 conditions in the basin were caused by a paleotopographic high forming a barrier to open ocean circulation. The western margin sedimentary deposits formed later than the fault-hosted hydrothermal deposits along the eastern margin, once a significant reservoir of Mn2+ and Fe2+ had developed, and when there was sufficient subsidence to allow migration of the redox front onto the shallow shelf, with Mn precipitation on and within the seafloor sediments. The sedimentary manganese deposits are not uniformly distributed along the western edge of the basin; instead they are concentrated into discrete areas (e.g. Mt Cooke–Utah–Mt Rove, Bee Hill, Skull Springs and the Ripon Hills districts), suggesting a degree of structural control on their distribution. Fault-hosted manganese is observed beneath and adjacent to many of the sedimentary deposits. Marked geochemical differences are observed between the Woodie Woodie hydrothermal deposits and the sedimentary deposits. Woodie Woodie deposits display higher Ba, U, Mo, As, Sn, Bi, Pb, S and Cu than the sedimentary deposits, reflecting the composition of the hydrothermal fluids. The Al2O3 values of the Ripon Hills and Mt Cooke deposits are much higher than the Woodie Woodie deposits, reflecting the composition of the dominant host rock, as Al2O3 is typically <5 wt% in the Carawine Dolomite, but is >10 wt% in basal shale units of the Manganese Group. Highly variable Mn:Fe ratios (≫5:1) in the hydrothermal manganese at Woodie Woodie reflects rapid deposition of Mn in and around fault zones. In contrast, slower accumulation of Mn oxides on and within the seafloor to form the large sedimentary deposits results in Mn:Fe ratios closer to 1:1 and elevated Co + Ni and REE values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.