Abstract
Amorphous silicon (a-Si) gates with a length of 20nm have been obtained in a ‘line & cut’ double patterning process. The first pattern was printed with EUV photoresist and had a critical dimension close to 30nm, which imposed a triple challenge on the etch: limited photoresist budget, high line width roughness and significant CD reduction. Combining a plasma pre-etch treatment of the photoresist with the etch of the appropriate hard mask underneath successfully addressed the two former challenges, while the latter one was overcome by spreading the CD reduction on the successive layers of the stack.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
