GaN thickness dependence of GaN/AlN superlattices on face-to-face-annealed sputter-deposited AlN templates

Abstract

Recently, deep-ultraviolet (DUV) light-emitting devices have attracted attention for various applications. GaN/AlN superlattices have emerged as a promising alternative for achieving high-efficiency DUV emission. To fabricate superlattices with high crystal quality and abrupt interfaces, we have utilized face-to-face-annealed sputter-deposited AlN template substrates characterized by a flat surface and low dislocation density. Furthermore, radio-frequency plasma-assisted molecular beam epitaxy with in situ reflection high-energy electron diffraction monitoring was employed for the growth process. The growth of the superlattices follows a specific sequence. Step 1: AlN growth, Step 2: conversion of Al droplets to AlN, Step 3: GaN growth, and Step 4: evaporation of Ga droplets. This study explored the impact of GaN thickness on the GaN/AlN superlattice. The GaN thickness was linearly controlled by changing the duration of Step 3. This approach allowed for the growth of a flat GaN layer up to 1 monolayer (ML) and achieved superlattices with abrupt interfaces. Single-peak cathodoluminescence (CL) emission at 240–245 nm was observed from the superlattices, with the peak shift toward longer wavelengths as the GaN thickness increased. In contrast, quantum dot-like GaN islands were generated with a thickness of over 1 ML, induced by compressive strain. Superlattices with thicker GaN exhibited broad CL emission with multiple peaks. However, the AlN barrier layer reduced the surface roughness and maintained abrupt interfaces within the superlattices. Therefore, to obtain sharp single-peak UV emission from GaN/AlN superlattices, the growth sequence should be controlled to obtain flat GaN layers without dots.