Full-scale experimental, numerical, and theoretical research on the spatio-temporal evolution of the flow structure in longitudinal and semi-transversal ventilated tunnels

Abstract

This paper presents full-scale experimental, numerical, and theoretical research on the spatial and temporal structure of airflow for different modes of ventilation system operation in a road tunnel. The tunnel under investigation is equipped with a semi-transverse ventilation system. There are 19 pairs of axial jet fans in each tunnel tube and 164 air supply vents on both sides of a tube located just above the road surface. A set of seven stand poles with mounted vane anemometers were arranged along the tunnel tube axis. Different configurations of axial jet fans and air supply vents were employed, and changes in airflow velocity were recorded. Since the main objective of the study is to achieve a deeper understanding of the examined phenomena, a numerical model of the flows in the tunnel was built, and the acquired data was used to validate it. Some theoretical considerations are provided and also validated. All of this together reveals a very uneven distribution of longitudinal air velocity along the tunnel axis. Then, time constants when switching the fans on and off are determined. It is shown that the time needed to achieve a stable flow after the fans are turned on is in the order of five minutes, and the decay time after the fans are turned off is much longer; it takes about 15 min to calm down the flow. Next, it is determined that the transverse air supply significantly changes the airflow structure: the average longitudinal air velocity at the inlet portal was up to 25% lower than without it, while values at the outlet portal were similar. Finally, it is indicated that axial fans that operate in the suction mode are similarly efficient to those in the pumping mode.