Abstract
In order to achieve the required air and product temperatures in refrigerated food display cabinets, the evaporator coils, which are normally located in the base of the cabinets, operate at temperatures below the freezing point of water. The air which is circulated over the evaporator coil is cooled below its dew point and water vapour present in the air condenses and eventually freezes on the coil surface. With continuous operation of the coil, frost will accumulate on the coil surface leading to a decrease both in the air flowrate and in the overall heat transfer coefficient. In order to maintain satisfactory performance, evaporator coils are defrosted periodically. Although different defrost control strategies can be employed, for simplicity and cost considerations, defrosting in supermarket refrigeration systems is usually controlled by a pre-set time cycle. It is widely acknowledged, however, that time-based defrost may cause a number of unnecessary defrost cycles and this reduces the energy efficiency of the refrigeration systems as well as the accuracy of temperature control of the cabinets. Implementing defrost only when it is needed or on ‘demand’ should reduce the number of defrost cycles and lead to savings in energy and improved product quality. This paper reports on field and experimental investigations on the processes of frosting and defrosting of medium-temperature display cabinet evaporator coils. The results show that for medium-temperature refrigeration applications where the environment temperature is kept reasonably constant, the store humidity is the primary parameter influencing the rate of frost formation. Using relative humidity as a control parameter the defrost frequency can be reduced considerably without affecting cabinet performance and product integrity. Alongside the effect of relative humidity, the paper also considers the effects of other performance parameters on the processes of frosting and defrosting such as cooling time and length of previous defrost cycle, and discusses ways in which some of these parameters may be used to implement defrost on demand.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.