Frictional properties of actinolite-chlorite gouge at hydrothermal conditions

Abstract

Exhumed subduction zones frequently show widespread actinolite-chlorite (Act-Chl) dominated compositions, suggesting that this may play an important role in controlling megathrust fault slip. We investigate the frictional behavior of simulated Act-Chl (85:15) gouge mixtures derived from natural mafic metamorphic rocks, under hydrothermal conditions using a ring shear deformation apparatus. Experiments were performed at effective normal stresses (σneff) of 50–200 MPa, pore fluid pressures (Pf) of 50–200 MPa, at temperatures (T) of 23–600 °C. In each experiment we applied a shear displacement (x) of ~10 mm at a constant sliding velocity (v) of 10 μm/s, followed by v-stepping in the range 0.3–100 μm/s, and slide-hold-slide (SHS) tests with hold times (t) ranging from 3 s to 3000 s. We quantified the rate- and state-dependent friction parameter (a-b), and investigated the effect of t on fault healing (Δμpk). The results showed no effects of temperature on the coefficient of friction (μ ≈ 0.6–0.7), or on (a-b), with some experiments showing persistent, displacement-hardening or -weakening trends. Nonetheless, effects of v and of normal stress (σn = σneff + Pf) on (a-b) fall into three temperature regimes: (1) T = 23–100 °C, (2) T = 200–400 °C, and (3) T = 500–600 °C. In Regimes (1) and (3), (a-b) > 0 for all conditions tested, whereas in Regime (2), (a-b) ≤ 0, at σneff = Pf = 50 MPa and v = 0.3–3 μm/s. We discuss on the origin of persistent displacement-hardening or -weakening trends observed, and assess the implications of our data for subduction zone seismogenesis. Extrapolation of (a-b)-data using multiple linear regression suggests that high pore pressure ratios (>0.9) are needed to promote seismogenesis in faults cutting actinolite-chlorite compositions.