Frequent analytical/experimental problems in lipase-mediated synthesis in solvent-free systems and how to avoid them

Abstract

Compared with chemical catalysis, enzymatic catalysis is a relatively new topic. Experimental work involving lipases deserves careful attention and accurate procedures still need to be implemented. A rapid but careful survey of published data immediately demonstrates that experiments performed under similar conditions with similar reagents have led to very different results. The aim of this work is to point out the importance of accurate and systematic procedures in order to ensure the reproducibility of experimental data. We strongly believe that different results found by different labs are due to problems detected in the procedures used. Quantification of the immobilisation efficiency of lipase on several supports through UV/visible methods and sampling methods used to obtain correct enzymatic activity values are specifically analysed. After a brief review which demonstrates the big discrepancies found in the literature, original data from Candida rugosa lipase adsorption on polypropylene powder and its use in the solvent-free synthesis of ethyl oleate are introduced in order to exemplify the difficulties found in these kinds of systems. Several procedures described in the literature are assayed and the accuracy of the results obtained is carefully analysed. The aim of the whole analysis performed is that it would be useful for any powdered solid to be used as a support for a lipase in a solvent-free system for any synthesis reaction, especially for those involving a volatile reagent. Throughout this contribution, special emphasis is placed on how catalytic reaction results using enzymes (free and immobilised) are reported so as to allow comparison between published data, something which is usually difficult since very different units are used and often complementary data are not included.