Abstract
The current trend in building low-cost yet flexible radio transceivers is to use the so-called direct-conversion principle, which is based on complex (I/Q) up- and down conversions. Such transceivers are, however, sensitive to mismatches between the I and Q branches. These mismatches are unavoidable in any practical implementation, and result in finite attenuation of the mirror frequencies. In addition to the mirror-frequency interference problem, I/Q mismatches can severely compromise the performance of power amplifier linearization techniques based on pre-distortion. The effects of these impairments are becoming more pronounced as higher order modulated waveforms and/or more wideband multichannel signals are used. This brief focuses on digital-signal-processor-based I/Q mismatch calibration in wideband direct-conversion transmitters, assuming the challenging case of frequency-dependent I/Q mismatch. First, a novel widely linear (WL) calibration structure is introduced, suitable for frequency-dependent calibration. Then, two alternative principles for calibration parameter estimation are proposed. The first estimation approach stems from second-order statistics of complex communication signals, while the second technique is based on WL least-squares model fitting. Both estimators are shown by simulations to yield very good calibration performance. The obtainable performance is further assessed using laboratory RF signal measurements.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call