Fracture toughness of freestanding plasma sprayed yttria stabilized zirconia coatings via in situ tensile experiments

Abstract

Tensile response and fracture toughness of the freestanding atmospheric plasma spray 8YSZ coatings was investigated using in situ high resolution optical full-field strain measurement. The elastic properties obtained directly from the tensile experiments were employed in computing the critical mode-I stress intensity factor. Comparison between the fracture toughness values computed from specimen geometry and J-integral via displacement field around the crack tip showed small differences on single edge notched tensile (SENT) specimens to extract their intrinsic mode-I fracture toughness. Two kinds of coatings having different porosity were studied to obtain stress-strain response and compute effect of porosity on mode-I fracture toughness. The samples were fabricated by depositing the coatings on, un-notched and pre-notched substrate templates, and then carefully separating the coatings by acidic dissolution of the substrate. High resolution in situ deformation of the coatings was captured for both tensile and SENT specimens using digital image correlation method combined with an in-house designed microtensile stage. The deformation from the specimen surface was used to obtain elastic material properties under uniaxial tension, which are then used to compute the energy release rate by the path independent J-integral. The critical stress intensity factors calculated from SENT geometry for the low and high porosity coatings were found to be 1.23 ± 0.21 MPa-m0.5 and 0.67 ± 0.12 MPa-m0.5, respectively. In addition, considering the experimental observation of nucleation and propagation of a crack from the notch tip before catastrophic failure, the J-integral based calculation of the critical fracture toughness values were 1.37 ± 0.19 MPa-m0.5 and 0.5 ± 0.1 MPa-m0.5, for the low and high porosity coatings, respectively. As the crack always nucleates from the notch before complete fracture, it can be concluded that the J-integral based method is accurate and suitable for finding the fracture toughness in porous coatings.