Fracture toughness and cavitation erosion behavior of Fe-based amorphous composite coatings with Ni-coated Al2O3 addition

Abstract

Fe-based amorphous composite coatings were prepared on 304 stainless steel substrates using atmosphere plasma spraying (APS), aiming to investigate the effect of Ni-coated Al2O3 particles addition on fracture toughness and cavitation erosion behavior of Fe-based composite coatings. The microstructure, phase composition, elastic modulus, microhardness and fracture toughness of the coating were characterized using scanning electron microscopy with energy dispersive spectroscopy (EDS), X-ray diffraction (XRD), microhardness tester and nanoindentation. The cavitation erosion behavior of Fe-based coatings was investigated by ultrasonic vibration cavitation method. Fe-based amorphous composite coatings exhibit a characteristic lamellar microstructure and reveal the presence of amorphous phases along with α-(Fe, Cr), NiO, Ni and Al2O3 crystalline phases. When the content of Ni-coated Al2O3 in coating increases from 0 wt% to 3 wt%, there is slight deterioration in porosity from 3.64 % to 4.75 % and fracture toughness from 2.579 MPa·m1/2 to 2.392 MPa·m1/2, yet an increase in microhardness from 925.4 HV0.5 to 1090.3 HV0.5. The composite coating with 3 wt% Ni-coated Al2O3 demonstrates the peak cavitation resistance and its cumulative mass loss is significantly reduced by 36.4 % compared to the pure Fe-based coating. The cavitation erosion failure of Fe-based amorphous composite coatings is predominantly characterized by the brittle fracture mechanism. The fundamental process driving cavitation erosion damage involves the material peeling and coating delamination instigated by intense micro-jet impact and shock wave propagation. The proposed Fe-based amorphous composite coatings can be applied to improve the anti-cavitation performance of components in contact with high-speed fluids, such as ship propellers and centrifugal pump blades.