Abstract
Double-side incremental forming of pure aluminum sheets was performed, and formed shapes were compared with those formed by single point incremental forming. Pure aluminum sheets were used for specimens and tools made of high speed steel with a diameter of 6 mm was employed for forming. The specimen sheet was formed into a frustum of pyramid shape. The cross-sectional shapes at the beginning of forming by double-side incremental forming were closer to the objective shape than that by double-side incremental forming. However, cross-sectional shape at the latter of forming by single point incremental forming became closer to the objective one.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
