Formation of high crystalline LDH sludge for removing Cu and Zn from wastewater by controlled double-jet precipitation.

Abstract

In order to improve the heavy metal wastewater treatment by avoiding formation of amorphous sludge phase, we develop a faster formation of high crystalline layered double hydroxide (LDH) sludge to remove Cu and Zn from wastewater by controlled double-jet precipitation (CDJP) without hydrothermal or heat aging post-treatment. A series of experimental procedures are conducted to determine the optimal parameters. Results show that the optimal adding rate, pH value, and stirring rate is 0.5mLmin-1, 9.0, and 500rpm, respectively. The CuZnAl-LDH phase sludge is formed in a well-crystallized hexagonal platelet, which assembled into a flower-like architecture. Comparative studies show that the formation of amorphous LDH sludge in conventional precipitation (CP) could be divided roughly into two stages-from the mixed copper hydroxide, zinc hydroxide, and scarbroite to the mixed low crystallinity CuAl-LDH and ZnAl-LDH. However, in CDJP method, the high crystalline LDH sludge evolved from a new four-step evolution process that is the formation of an amorphous (quasi-)multinary metastable ternary CuZnAl-LDH phase, followed by the indiffusion of cations and substitution of anions to fabricate crystalline LDH, the integrated LDH hexagonal platelets assembled into a flower-like architecture by the screw dislocation growth mechanism, the coarsening growth of each ternary LDH platelet, respectively. Thereinto, the formation of (quasi-)multinary metastable LDH phase instead of metal hydroxide in initial stage would be an obvious advantage of the CDJP method compared to CP method due to the former skipping the sequential precipitation.