Formation of boride layers on a commercially pure Ti surface produced via powder metallurgy

Abstract

Abstract In this study, powder metallurgy was applied in a furnace atmosphere to form titanium boride layers on a commercially pure Ti surface. Experiments were carried out using the solid-state boriding method at 900 °C and 1000°C for 12 h and 24 h. Samples were produced by pressing the commercially pure Ti powders under 870 MPa. The sintering process required by the powder metallurgy method was carried out simultaneously with the boriding process. Thus, the sintering and boriding were performed in one stage. The formation of the boride layer was investigated by field emission scanning electron microscopy, optical-light microscopy, X-ray diffraction, and elemental dispersion spectrometry analyses. In addition, microhardness measurements were performed to examine the effect of the boriding process on hardness. The Vickers microhardness of the boronized surface reached 1773 HV, which was much higher than the 150 HV hardness of the commercially pure Ti substrate. The X-ray diffraction analysis showed that the boriding process had enabled the formation of TiB and TiB2 on the powder metallurgy Ti substrate surface. Consequently, the production of Ti via powder metallurgy is a potentially cost-effective alternative to the conventional method, and the boriding process supplies TiB and TiB2 that provide super-high hardness and excellent wear and corrosion resistance.