Forging-Submerged Arc Additive Hybrid Manufacturing of the Mn-Mo-Ni Component: In Situ Reheat Cycles Inducing the Homogenization of the HAZ Microstructure.

Abstract

Listen

Translate article

Forging additive hybrid manufacturing integrated the high efficiency of forging and the great flexibility of additive manufacturing, which has significant potential in the construction of reactor pressure vessels (RPVs). In the components, the heat-affected zone (HAZ, also called as bonding zone) between the forged substrate zone and the arc deposition zone was key to the final performance of the components. In this study, the Mn-Mo-Ni welding wire was deposited on the 16MnD5 substrate with a submerged arc heat source. The in situ reheat cycle effect of the submerged arc heat source on the microstructure and mechanical properties of the HAZ were studied. The results showed that the HAZ underwent four heat treatment processes, including two full austenitizing stages, one high-temperature stage, and continuous low-temperature tempering, which formed a homogenized microstructure in the HAZ and was mainly composed of tempered sorbite (Tempered-S). The HAZ microhardness is around 278.7 HV, which is about 150 HV lower than the microhardness only conducted by one thermal cycle. Furthermore, the effects of preheating the substrate and adjusting the heat inputs on the HAZ were studied. The results indicated that the clustered cementite was precipitated, which destroys the low-temperature impact toughness of the HAZ after preheating. A suitable heat input not only homogenized the microstructure within the HAZ but also promoted the transformation of grains into equiaxed grains. The -60 °C impact toughness of the HAZ was significantly increased from 96.7 J to 113 J.