Abstract

Estimating applied force using force myography (FMG) technique can be effective in human-robot interactions (HRI) using data-driven models. A model predicts well when adequate training and evaluation are observed in same session, which is sometimes time consuming and impractical. In real scenarios, a pretrained transfer learning model predicting forces quickly once fine-tuned to target distribution would be a favorable choice and hence needs to be examined. Therefore, in this study a unified supervised FMG-based deep transfer learner (SFMG-DTL) model using CNN architecture was pretrained with multiple sessions FMG source data (Ds, Ts) and evaluated in estimating forces in separate target domains (Dt, Tt) via supervised domain adaptation (SDA) and supervised domain generalization (SDG). For SDA, case (i) intra-subject evaluation (Ds ≠ Dt-SDA, Ts ≈ Tt-SDA) was examined, while for SDG, case (ii) cross-subject evaluation (Ds ≠ Dt-SDG, Ts ≠ Tt-SDG) was examined. Fine tuning with few “target training data” calibrated the model effectively towards target adaptation. The proposed SFMG-DTL model performed better with higher estimation accuracies and lower errors (R2 ≥ 88%, NRMSE ≤ 0.6) in both cases. These results reveal that interactive force estimations via transfer learning will improve daily HRI experiences where “target training data” is limited, or faster adaptation is required.

Highlights

  • Force myography is a contemporary, non-invasive, wearable technology like the traditional surface electromyography and can read muscle contractions without requiring skin preparations or precautions

  • In this study a unified supervised force myography (FMG)-based deep transfer learner (SFMG-DTL) model using convolutional neural network (CNN) architecture was pretrained with multiple sessions FMG source data (Ds, Ts ) and evaluated in estimating forces in separate target domains (Dt, Tt ) via supervised domain adaptation (SDA) and supervised domain generalization (SDG)

  • Signal has similar characteristics, and there is a gap in the literature using transfer learning for the physical human robot interactions (pHRI) regression problem, this study focuses on force estimation using multiple session data sets via transfer learning

Read more

Summary

Introduction

Force myography is a contemporary, non-invasive, wearable technology like the traditional surface electromyography (sEMG) and can read muscle contractions without requiring skin preparations or precautions. This technology is based on force sensing resistors (FSRs) that detect resistance changes when pressure is applied to them. SEMG technology has been around for several decades, the measured electrical activities of underlying muscles during movements of limbs are faint, requiring substantial and costly signal processing units and skin preparation for electrode placements [2]. Transfer learning for hand gesture classification using convolutional neural network (CNN)

Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.