Fluorometric determination of mercury(II) via a graphene oxide-based assay using exonuclease III-assisted signal amplification and thymidine-Hg(II)-thymidine interaction.

Abstract

A highly sensitive and selective fluorometric method is described for determination of mercury(II). It is based on (a) the use of graphene oxide (GO) acting as a quencher of the fluoresence of the carboxy-fluorescein (FAM), and (b) of Hg(II)-triggered cleavage of the newly formed nucleic acid sequences harbored blunt 3'-hydroxyl termini by exonuclease III (Exo III) that leads to signal amplification. Two DNA probes are used, viz. a capture probe (CP) and a help probe; HP) that is partially complementary. In the absence of Hg(II), the FAM-labeled hairpin (signal probe, SP) is adsorbed onto the surface of GO via π-stacking interactions. CP blocks the release of the HP for binding to SP. This results in quenching of the green fluorescence of the label. Upon addition of Hg(II), the linear structure of CP is converted to a hairpin structure due to the formation of thymidine-Hg(II)-thymidine duplexes. HP is released from the CP/HP hybrids, and this causes SP to be released from from GO and fluorescence to be recovered. The signal is strongly amplified by using Exo III-assisted targeting and recycling of HP. Hence, Hg(II) can be detected via the strong increase in fluorescence. The method has a linear response in the 0.1 to 30nM Hg(II) concentration range and a 10 pM detection limit. It was applied to the determination of Hg(II) in three (spiked) Chinese medicines. Graphical abstract Schematic representation of fluorescence sensing strategy for Hg2+ by using graphene oxide as a quencher and exonuclease III-assisted signal amplification.