Abstract
In this study, for the first time, jamun seed derived activated carbon was used as an adsorbent for removal of fluoride from water. Activated carbon was prepared by KOH activation of jamun seed and subsequent pyrolysis at 900°C. The fluoride sorption experiments were carried out under batch mode to optimize the various influencing parameters such as contact time (0–3h), dosage of adsorbent (20–500mg), initial fluoride concentration (2–20mgL−1), temperature (298–308–318K), and pH (2.5–10). The contact time and pH for maximum fluoride uptake were observed at 120min and 2.5 respectively. Maximum adsorption capacity (3.65mg g-1) of fluoride on activated carbon was found for 10mgL−1 of initial fluoride concentration using 0.4gL−1 adsorbent dosage. The equilibrium data were found to follow Dubinin-Radushkevich isotherm among the three applied isotherm models (Freundlich, Temkin, and Dubinin-Radushkevich) and pseudo-second-order kinetic mechanism with the rate constant of 0.036gmg−1min−1. Thermodynamic analysis revealed that the adsorption process was exothermic in nature. Performance of the prepared adsorbent was compared with other reported biomass derived activated carbons and it was observed that the proposed adsorbent is efficient in terms of its adsorption capacity. In addition to synthetic samples, field water samples collected from fluoride affected villages were also tested for adsorption experiments.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
