Abstract
Dual distribution systems are becoming increasingly common in greenfield housing developments in Australia for the redistribution of recycled water to households for non-potable use. Within such schemes there exists the potential for cross-connections between recycled and drinking water systems. Due to the high level of recycled water treatment, these events are unlikely to lead to outbreaks of illness in the community. Nonetheless, they do represent a breach of the recycled water risk management strategy and therefore an elevated level of risk to consumers. Furthermore, cross-connection events have the potential to undermine public confidence in these types of water recycling. A rapid, highly sensitive method of cross-connection detection may therefore provide an additional level of confidence in these schemes. The aim of this research was to determine the potential for using fluorescence spectroscopy as a monitoring tool in water treatment plants and dual distribution systems. Samples from both the water recycling plant and dual distribution system were collected on a weekly basis over 12 weeks. Fluorescence excitation–emission matrix (EEM) spectra and water quality parameters including dissolved organic carbon, UV 254, pH, conductivity, free chlorine and turbidity were obtained for each sample. The fluorescence EEM spectra of recycled and drinking water were distinctly different and exhibited low variability throughout the course of the sampling program, indicating a degree of stability of the fluorescent components within the organic matter. A ten-fold difference in mean fluorescence intensity was observed for recycled water compared to drinking water, which was greater than the difference observed for the other measured water quality parameters. Probabilistic analysis was used to determine the reliable detection limit of recycled water contamination of drinking water. Accounting for the inherent variability of both recycled water and drinking water, a 45% contamination of recycled water in drinking water could be detected with a signal-to-noise ratio greater than 3 for more than 95% of individual random sample pairs. Greater sensitivity can be assured by averaging numerous samples. In comparison, a 70% contamination of recycled water in drinking water was required for the same detection using conductivity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.