Abstract

The residual free chlorine concentration is an important parameter to evaluate the potability of water and the efficiency of disinfection in the water treatment system. As a restricted range of residual free chlorine concentration at all points of the distribution network is needed to ensure efficiency and to avoid deleterious effects, fast and in situ quantification of this specie is important. This work deals with the development and validation of two procedures based on DPD (N,N-diethyl-p-phenylenediamine) and OT (ortho-tolidine, 3,3-dimethylbenzidine) for the determination of residual free chlorine in water by exploiting a flow-based microdevice built with Low Temperature Co-Fired Ceramic (LTCC) technology. The analytical signal was monitored by a smartphone camera through RGB values obtained by a free application (Color Grab®). Under optimized conditions, linear ranges within 0.6–2.5 mg/L and 0.1–2.3 mg/L were obtained for DPD and OT methods, with limits of detection and quantification of 0.023 and 0.077 mg/L (DPD) and 0.026 and 0.089 mg/L (OT). Precision expressed as RSD (2.0 mg/L free chlorine, n = 10), was 1.3 % and 0.7 %, respectively. Both procedures were successfully applied to the analysis of samples from a water treatment plant. The flow-based microdevice coupled to digital-image colorimetry is an innovative, sustainable, and cost-effective analytical tool for in-field chemical analysis.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.