Abstract
Flow and heat transfer characteristics of submerged impinging water jets were experimentally investigated. Air was mixed with water using a venturi tube installed before a pipe nozzle. The effects of the volumetric air fraction (β = 0.0–0.7) and jet impingement distance (L/D = 2–8) were studied at a water jet Reynold number, Rew, of 24,000. The air-water flow in the pipe nozzle and impinging air-water jet was recorded using a high-speed camera. An infrared thermal imaging camera measured local heat transfer on the impingement surface. Results show that heat transfer depends strongly on the volumetric air fraction. Impingement distance also affects the behavior of air bubbles in the water jet. Air bubbles can increase the heat transfer on the impingement region by increasing turbulence intensity in the jet with small air bubbles or an intermittent effect of large air bubbles impinging on the surface. Impinging jets where L/D = 4 with β = 0.3 and L/D = 2 with β = 0.2 give the highest heat transfer enhancement, about ∼47% compared to the case of β = 0.0.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.