Flame-Retardance Functionalization of Jute and Jute-Cotton Fabrics.

Abstract

Jute is a ligno-cellulosic natural fiber that ranks second in terms of the volume of cellulosic fibers and is extensively utilized for technical textile applications. The goal of this study is to determine the flame-retardance (FR) properties of pure Jute and Jute-Cotton fabrics treated with Pyrovatex CP New at concentrations of 90% (owf), M:L: 1:7. Both fabrics exhibited a substantial improvement in flame-retardancy. After the ignition period, the recorded flame spread time in both FR treated fabrics was zero seconds; whereas for untreated Jute and Jute-Cotton fabrics, the flame spread time was measured 21 s and 28 s, respectively, to burn their entire length (15 cm). Within these flame-spread times, the length of the char was 2.1 cm and 2.57 cm in the Jute and Jute-Cotton fabrics, respectively. After FR finishing, on both fabrics in the warp and weft directions, the physico-mechanical properties significantly decreased. The deposition of flame-retardant finishes on the fabric surface was determined by Scanning Electron Microscope (SEM) images. According to Fourier Transform Infra-Red Spectroscopy (FTIR) analysis, the flame-retardant chemical had no effect on the inherent properties of the fibers. Thermogravimetric analysis (TGA) analysis revealed that FR treated fabrics had early degradation, resulting in the formation of more char than in the untreated samples. After FR treatment, both fabrics showed a significant improvement in residual mass (more than 50%). Although the formaldehyde content observed in the FR treated samples was significantly greater, it was still within the permitted limit formaldehyde content in textiles intended for outerwear and not worn next to the skin. The results of this investigation demonstrate the potential use of Pyrovatex CP New in jute-based materials.