Abstract
In this paper, a fault diagnostic method is proposed for autobody assembly fixtures. This method uses measurement data to detect and isolate dimensional faults of part caused by fixture. The proposed method includes a predetermined variation pattern model and a fault mapping procedure. The variation pattern model is based on CAD information about the fixture geometry and location of the measurement points. This fault mapping procedure combines Principal Component Analysis with pattern recognition approach. Simulations and one case study illustrate the proposed method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
