Finite Element based Numerical Modelling of Near-Dry EDM with Glycerin-Air Dielectric Mixture

Abstract

Electrical discharge machining (EDM) is an advanced, non-traditional machining process that is widely employed in sectors such as manufacturing, automotive, aerospace, and medicine. Near-dry EDM is a prospective technology that offers advantages over dry and wet EDM in terms of material removal rate (MRR), tool wear rate (TWR), and surface integrity. A 2D model of the axi-symmetric workpiece based on the Gaussian distribution of the heat flux is used to simulate the single spark in near-dry EDM. The MRR of near-dry EDM is determined at various glycerin flow rates in the glycerin-air combination. The simulation is then performed on the SS304 workpiece with different glycerin flow rates. The results are compared to EDM simulations using N2 and O2 as the dielectric medium. The average MRR of near-dry EDM with an 8 ml/min glycerin flow rate is determined to be 204% higher than that of N2 and 117% higher than that of O2 gas dielectric. When the volumetric ratio of glycerin in the glycerin-air combination increases, the MRR was also found to be increasing. The maximal MRR of near-dry EDM was found to be 129.30703 mm3/min with an 8 ml/min glycerin flow rate and a 0.18 volumetric ratio and a maximal MRR of 144.3407 mm3/min was found with a 15 ml/min glycerin flow rate and a 0.35 volumetric ratio.