Finite element analysis of type IV cracking in 2.25Cr–1Mo steel weldment based on micro-mechanistic approach

Abstract

Creep studies were carried out on 2.25Cr–1Mo steel base metal and its fusion-welded weldments at 823 K over the stress range 100–240 MPa. The weldment possessed lower creep rupture strength than the base metal due to type IV failure at the outer edge of the heat-affected zone (HAZ). Premature failure of the weldment was associated with pronounced creep cavitation accompanied with localized creep deformation in the soft intercritical region of the HAZ that was sandwiched between relatively higher creep deformation-resistant microstructural regions. The cavitation was associated with coarse intergranular precipitates in the intercritical region of the HAZ. The type IV cracking in the intercritical region of the HAZ was found to initiate deep inside the weldment and propagate towards the specimen surface. Finite element analysis of stress and strain distributions across the weldment was carried out considering the micro-mechanical strength inhomogeneity across it to explain the observed features of type IV cracking. The estimated higher von-Mises and principal stresses deep inside the intercritical region of the HAZ of the weldment led to the localized creep deformation and preferential cavity nucleation and growth, resulting in type IV failure of the weldment. The role of intergranular precipitate particles in the intercritical region of the HAZ in facilitating creep cavity nucleation by the exhaustion of creep ductility of the material close to the precipitate was corroborated from finite element analysis of stress and strain distribution around the precipitates.