Feedforward control to suppress the leading edge bulge in photopolymerization-based additive manufacturing

Abstract

PurposeThis study aims to examine the feasibility of feedforward actuation of the recoater blade position to alleviate the resin surface non-uniformity while moving over deep-to-shallow transitions of submerged (already cured) geometric features.Design/methodology/approachA two-dimensional computational fluid dynamics (CFD) model has been used to determine optimized blade actuation protocols to minimize the resin surface non-uniformity. An experimental setup has been designed to validate the feasibility of the proposed protocol in practice.FindingsA developed protocol for the blade height actuation is applied to a rectangular stair-like configuration of the underlying part geometry. The evaluation of the actuation protocol revealed the importance of two physical length scales, the capillary length and the size of the flow recirculation cell below in the liquid resin layer below the blade. They determine, together with the length scales defining the topography (horizontal extent and depth), the optimal blade trajectory. This protocol has also shown its efficiency for application to more complicated shapes (and, potentially, for any arbitrary geometry).Practical implicationsThis study shows that incorporation of a feedforward control scheme in the recoating system might significantly reduce (by up to 80%) the surface unevenness. Moreover, this improvement of performances does not require major modifications of the existing architecture.Originality/valueThe results presented in this work demonstrate the benefits of the integration of the feedforward control to minimize the leading edge bulges over underlying part geometries in stereolithography.