Feasibility of using BeO rods as secondary neutron sources in the long-life fuel cycle high-temperature gas-cooled reactor

Abstract

External sources of neutron provide stable and sufficient neutron for initial startup of a nuclear reactor. They also provide signals for neutron detectors to monitor the safety of reactor during shutdown. In the high temperature engineering test reactor (HTTR), 252Cf is used as the external neutron source. However, the 252Cf sources must be renewed every approximately 7 years because of its relatively short half-life of 2.6 years. The renewal of 252Cf sources requires a high cost and a very complicated procedure. This study investigated the feasibility of using BeO rods as the secondary neutron sources to avoid renewing the 252Cf neutron sources periodically. The BeO rods could exist in the reactor for a long time so that if the reactor operates long enough, the neutron flux at the wide-range monitoring detectors remains more than 10n.s−1.cm−2 even if the reactor is shutdown for as long as 5 years. The results of this study indicated that using BeO rods as the secondary neutron sources would be an attractive option for the future HTGR design with a long-life fuel cycle.