Feasibility of anterior pedicle screw fixation in lumbosacral spine: a radiographic and cadaveric study

Abstract

BackgroundThe anterior pedicle screw (APS) technique for L5 and S1 is crucial for proper anterior lumbar interbody fusion (ALIF). This study aimed to determine the projection, screw trajectory angle, and bone screw passageway length (BSPL), as well as the screw insertion regularity and the operating area within which it is safe to perform insertion.MethodsForty patients with low back pain, all of whom had lumbar computed tomography scans available, was included in this retrospective analysis. Radiographic parameters were measured, including: the distances from the projection to the upper endplate, lower endplate, and midline; the transverse and sagittal screw angles; and the BSPL. In addition, 10 fresh adult cadaveric lumbosacral spine segments were selected to determine the safe anatomic area in which to operate. Finally, APSs were inserted in L5 and S1 to determine the regularity of APS insertion.ResultsWe measured the anterior projection parameters, including: the distances to the upper endplate (L5: 12.5±1.3 mm; S1: 4.54±0.87 mm), lower endplate (L5: 17.3±1.6 mm), and midline (L5: 6.6±0.7 mm; S1: 6.6±0.6 mm); the screw trajectory angle, including the transverse screw angle (L5: 25.3±2.8°; S1: 25.7±2.6°), sagittal screw angle (L5: 17.1±1.7°; S1: 22.4±1.1°); and the BSPL (L5: 48.6±3.5 mm; S1: 48.0±3.5 mm). The regularity of APS insertion in L5 and S1 was determined. Upon the needle reaching a point in the lateral view, it reached the corresponding point in the anteroposterior (AP) view. The anatomic parameters of the safe operating area were as follows: the distance from the abdominal aortic bifurcation to the L5 lower edge (40.50±9.40 mm); the distance from the common iliac vein confluence to the L5 lower edge (27.80±8.60 mm); and the horizontal distance from the inner edge of the common iliac vein to the L5 lower edge (37.50±1.30 mm). We also determined the distance between S1 holes (29.30±1.30 mm), the L5/S1 intervertebral height (17.20±1.50 mm), and the safe operating area (2,058.20±84.30 mm2).ConclusionsThis study has determined the projection, screw trajectory angle, and BSPL of APSs in L5 and S1, their insertion regularity, and the area in which the operation can be safely performed.