Abstract

The line-commutated converter (LCC)-based high voltage direct current (HVDC) technology has been widely applied on long-distance and bulk-capacity power transmission occasions. Due to the terrible interferences in the vicinity of communication lines, DC filters (DCFs) are always installed to mitigate the interferences within acceptable levels for almost all in-service overhead line transmission LCC-HVDC schemes. With the rapid development of the communication technology, however, the anti-interference capability of the telephone system has been remarkably improved. Thus, the original purpose of employing DCFs has been virtually absent, and the necessity of the DCFs shall be re-evaluated in sufficient depth not only for new LCC-HVDC projects, but also in the case of refurbishment of older projects. To demonstrate this constructive topic, this paper carries out a commercial ±800 kV/8000 MW LCC-HVDC project as an illustrative example to analyze and discuss those crucial aspects, which may influence the LCC-HVDC stable operation and reliability after removing the DCFs. Then, the paper studies the harmonic voltage/current stresses of the DC equipment, the DC loop low-order harmonic resonances, and the overvoltage under the switching surge and lightning stroke. Finally, it is concluded that the DCF elimination mainly affects the harmonic steady-state stresses of the DC equipment, but has little influence on the transient stresses. For the refurbishment of older projects, the evaluation on the cost between the DCFs’ maintenance cost and the equipment modification is needed for the DCFs’ elimination. For new LCC-HVDC projects, the DCFs’ elimination or at least simplification may be a more economical and attractive alternative, thereby reducing the footprint and cost.

Highlights

  • To fulfill the ever-growing energy demand, high-voltage direct current (HVDC) transmission technology has drawn an indispensable role on long-distance and bulk-capacity power transmission occasions, notably the vast territory areas where the energy sources and load demands are distributed unevenly [1,2,3,4,5]

  • DC filters (DCFs) shall be re-evaluated in sufficient depth for new line-commutated converter (LCC)-high voltage direct current (HVDC) projects, and in the case of refurbishment of older projects. To demonstrate this constructive topic, this paper carries out a commercial ±800 kV/8000 MW LCC-HVDC project as an illustrative example to analyze and discuss those crucial aspects, which may influence the LCC-HVDC stable operation and reliability after removing the DCFs

  • It is concluded that the DCF elimination mainly affects the harmonic steady-state stresses of the DC equipment, but has little influence on the transient stresses

Read more

Summary

Introduction

To fulfill the ever-growing energy demand, high-voltage direct current (HVDC) transmission technology has drawn an indispensable role on long-distance and bulk-capacity power transmission occasions, notably the vast territory areas where the energy sources and load demands are distributed unevenly [1,2,3,4,5]. For almost all in-service overhead line transmission LCC-HVDC schemes, the DC filters (DCFs) are always installed to mitigate the interferences within. A potential state-of-the-art communication the original ofdepth employlargeWith cost the reduction, the necessity of the DCFstechnology, shall be re-evaluated inpurpose sufficient not ing DCFs to suppress the inductive interference virtually absent. To the best of the knowledge of the authors, up till only [21] proposed this topic, while no related literature has presented the compre ofcar hensive analysis and argument To demonstrate this constructive question, this paper ries out a commercial LCC-UHVDC project as an illustrative example. In order to comprehensively research the impacts on the harmonic steady-state mature technologies (i.e., the standard steady-state frequency-domain analysis, and stresses and the transient stress on DC-side apparatus after removing the DCFs, the PSCAD/EMTDC simulation) are adopted.

Section 3 introduces system modeling and the
Development of Communication
Subsection
DC Transmission Line Model
Solution for the DC-Side Circuit
Equivalent
Parameters of the Test System
DC-Side Harmonic Filtering System
DC Transmission Lines
Surge Arrester Scheme
E: Neut ral b us arrester
Parameters
Study on Steady Stress
Voltage at the DC Line Inlet
DC Loop Impedance
Summary
Switching Overvoltage
Conclusions
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.