Abstract
Fibre reinforced plastics (FRP) composites have been widely used in the automotive industry with the primary focus on reduced mass. However, there are relatively few reports on their application on power transmission components, such as drive shafts. This paper explores the feasibility of replacing the traditional structural steel by light weight FRP composites in a drive shaft. Three FRP composites are considered against a steel drive shaft; basalt/epoxy, carbon/epoxy, and CNT (carbon nanotubes) reinforced carbon/epoxy composites. The mechanical performance was analysed by finite element analysis (FEA) tool and classical laminate theory (CLT), while the environmental performance was evaluated by life cycle assessment (LCA) method. The study shows that with careful design a composite drive shaft can outperform the mechanical performance of a steel shaft (up to 90% mass saving, and 50% higher Factor of Safety). The study found steel shafts were preferable to FRP shafts based on embodied energy (steel total embodied energy 150MJ, FRP +325MJ). Reductions in carbon footprint from reduced emissions due to weight savings meant a carbon/epoxy shaft was preferable to a steel shaft. Two new material indices were suggested which can be used to select materials based on minimum embodied energy and global warming potential.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
