Abstract
AbstractEven though friction stir welding (FSW) has been shown to produce high performing butt joints, stress concentration at the weld edges in overlap FSW significantly reduces the performance of these joints. By combining FSW and adhesive bonding into a friction stir (FS) weld bonding, joint mechanical performance is greatly improved. Quasistatic and fatigue strength of the proposed FS weld‐bonding joints was assessed and benchmarked against overlap FSW and adhesive bonding. The characterization of the structural adhesive is also presented, including differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA), as well as mechanical characterization with curing temperature. A small process parameter study was made to select proper FSW parameters for AA6082‐T6 overlap FSW and FS weld‐bonded joints. FS weld bonding achieved a significant increase in quasistatic and fatigue strength when compared with overlap FSW, with 79.9% of the fatigue strength of adhesive‐bonded joints at 106 cycles, whereas FSW had 41.6%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Fatigue & Fracture of Engineering Materials & Structures
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
