Abstract
The biaxiality effect, especially the effect of non-singular stress cycling, on the fatigue behavior was studied, employing cruciform specimens of aluminum alloys 1100-H14 and 7075-T651. The specimens, containing a transverse or a 45 o inclined center notch, were subjected to in-phase (IP) or 100% out-of-phase (hereinafter referred to as “out-of-phase or OP”) loading of stress ratio 0.1 in air. The biaxiality ratio λ ranged from 0 to 1.5, and 3 levels of stress were applied. It was observed that: (1) at a given λ, a lower longitudinal stress induced a longer fatigue life under IP and OP loading, and the fatigue life was longer under IP loading, (2) the fatigue crack path profile was influenced by λ, phase angle (0 o or 180 o), and initial center notch (transverse or 45 o inclined); (3) the fatigue crack path profiles, predicted analytically and determined experimentally, had similar features for the specimens with a transverse center notch under IP loading; and (4) the fatigue crack growth rate was lower and the fatigue life longer for a greater λ under IP loading, whereas it changed little with change in λ under OP loading. These results demonstrate that non-singular stress cycling affects the biaxial fatigue behavior of aluminum alloys 1100-H14 and 7065-T651under IP and OP loading.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call