Abstract

Extreme freeform mirrors couple a non-axisymmetrical shape and an extreme asphericity, i.e. more than one millimeter of deviation from the best fit sphere. In astronomical instrumentation, such a large asphericity allows compact instruments, using less optical components. However, the lack of freeform mirrors manufacturing facilities is a real issue. We present the concept and development of an innovative manufacturing process based on plasticity forming which allow imprinting permanent deformations on mirrors, following a pre-defined mold. The aim of this activity, pursued in the frame of the OPTICON-FAME (Freeform Active Mirrors Experiment) project, is to demonstrate the suitability of this method for VIS/NIR/MIR applications. The process developed can operate on thin and flat polished initial substrates. Three study cases have been highlighted by FEA (Finite Element Analysis) and the real tests associated were performed on thin substrates in AISI420b stainless steel with 100 mm optical diameter. A comparison between FEA and tests is performed to study the evolution of the mechanical behaviour and the optical quality. The opto-mechanical results will allow a fine tuning of FEA parameters to optimize the residual form errors obtained through this process to converge toward an innovative and recurrent process.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.