Abstract
The objective of this study is to evaluate the reliability of through-aluminum-nitride-via (TAV) substrate by comparing those experimental results with the finite element simulation associated with measurements of aluminum nitride (AlN) strength and the thermal deformation of Cu/AlN bi-material plate. Two reliability tests for high-power LED (Light emitting diode) applications are used in this study: one is a thermal shock test from −40°C to 125°C, the other is a pressure cook test. Also, the strength of AlN material is measured by using three-point bending test and point load test. The reliability results show that TAV substrates with thicker Cu films have delamination and cracks after the thermal shock test, but there are no failure being found after the pressure cook test. The determined strengths of AlN material are 350MPa and 650MPa from three-point bending test and point load test, respectively. The measurement of thermal deformation shows that the bi-material plate has residual-stress change after the solder reflow process, also indicating that a linear finite element model with the stress-free temperature at 80°C can reasonably represent the stress state of the thermal shock test from −40°C to 125°C without considering Cu nonlinear effect. The further results of the finite element simulation associated with strength data of AlN material have successfully described those of the reliability test.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
