Abstract
In order to analyze the reason why tooth surface finish of the inner gear rings for coal cutters can not meet the standard requirement, a series of experimental studies are carried out on the gear-shaping cutter and the corresponding cutting parameters. It is found that the tooth surface finish can not reach the standard after machining with each cutting parameter by using a M2 high-speed steel cutter. Using a M42 high-speed steel cutter + Balchas coating, the tooth surface finish under each cutting parameter can meet the standard requirement. Combining with the requirements of machining efficiency and tooth surface finish, the matching cutting parameters are proposed. This study has guiding significance for improving the tooth surface finish of the inner gear rings for the coal cutters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
