Fabrication of polycrystalline diamond microtool using a Q-switched Nd:YAG laser

Abstract

A Q-switched Nd:YAG laser (1,064 nm, 100 ns) was used to machine 2 × 1.5 × 0.5-mm rhombus-shaped tool inserts from a 60 × 0.5-mm circular disk of polycrystalline diamond. A systematic experimental study was undertaken to examine the effects of pulse repetition rate, feed rate, and number of laser passes on kerf, material removal rate, recast layer, surface morphology, and surface roughness. The optimal laser parameters for generating two-dimensional tool profiles were an average power of 3 W, a pulse repetition rate of 2 kHz, a feed rate of 1 mm/s, and a total of 45 laser passes. The beneficial results were a material removal rate of 0.02 mm3/min, kerf width of 27 μm, cutting edge radius of 6 μm, and surface roughness (Ra) of 0.625 μm. Recast layer formation, undulations, and striations were observed in the laser-cut regions. These features were attributed to the presence of a molten layer of cobalt binder, and amorphous carbon and graphite transitioned from diamond. An intriguing feature is the presence of fine particulate matter ranging in size from nanometers to a few micrometers in the laser-cut regions. It is believed that phase transition of diamond and cobalt during laser machining created thermal expansion mismatch stresses sufficient to fracture the solid into fine fragments.