Abstract
This paper discusses the effect of pulse repetition rates on silicon wafer modification by four-beam laser interference. In the work, four-beam laser interference was used to pattern single crystal silicon wafers for the fabrication of dots, and different laser pulse repetition rates were applied to the process in the air. The results were obtained from 10 laser exposure pulses with the single laser fluence of 283mJ/cm2, the pulse repetition rates were 1Hz, 5Hz and 10Hz, the laser wavelength was 1064nm and the pulse duration 7-9ns. The results have been observed using a scanning electron microscope (SEM) and optical microscope. They indicate that the laser pulse repetition rate has to be properly selected for the fabrication of the structures of dots using four-beam laser interference.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.