Abstract
AbstractIn this study, we fabricated a plastic microfluidic device embedded with polycaprolactone (PCL) nanofibrous membrane for use as a filter for the removal of bacteria from contaminated water. A microfluidic device was fabricated by sandwiching an electrospun PCL nanofibrous membrane between two layers of poly(methyl methacrylate) (PMMA) substrates. On the top PMMA layer, a serpentine microchannel was engraved, and 165 through holes were drilled along the microchannel. The bottom PMMA layer contained four rectangular pillars in the center to prevent the collapse of the PCL membrane. To reduce the hydrophobic nature of the PCL membrane and to allow it attain antimicrobial functionality, the surfaces of the nanofibers were coated with dopamine. Scanning electron microscopy, Fourier transform infrared spectroscopy, and contact angle measurements confirmed the successful fabrication of the hydrophilic PCL membrane. Contaminated water was introduced at a flow rate of 2 mL/hr, screening 10 mL of fluid within 5 hr. Ultraviolet visible spectrophotometry and colony forming unit counting confirmed the removal of bacteria from contaminated water as compared with control (up to 80%), while dopamine‐coated nanofibrous membranes also exhibited antimicrobial activities. This justified the potential of utilization of the microfluidic device in water treatment systems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.