Fabrication of hexagonal boron nitride based 2D nanopore sensor for the assessment of electro-chemical responsiveness of human serum transferrin protein.

Abstract

In this work, we present a step-by-step workflow for the fabrication of 2D hexagonal boron nitride (h-BN) nanopores which are then used to sense holo-human serum transferrin (hSTf) protein at pH ∼8 under applied voltages ranging from +100mV to +800mV. 2D nanopores are often used for DNA, however, there is a great void in the literature for single-molecule protein sensing and this, to the best of our knowledge, is the first time where h-BN-a material with large band-gap, low dielectric constant, reduced parasitic capacitance and minimal charge transfer induced noise-is used for protein profiling. The corresponding ΔG (change in pore conductance due to analyte translocation) profiles showed a bimodal Gaussian distribution where the lower and higher ΔG distributions were attributed to (pseudo-) folded and unfolded conformations respectively. With increasing voltage, the voltage induced unfolding increased (evident by decrease in ΔG) and plateaued after ∼400mV of applied voltage. From the ΔG versus voltage profile corresponding to the pseudo-folded state, we calculated the molecular radius of hSTf, and was found to be ∼3.1nm which is in close concordance with the literature reported value of ∼3.25nm.