Abstract
Micro-powder injection moulding (micro-PIM) is an advanced net-shaping process for the fabrication of metal and ceramic complex micro-components. Cemented tungsten carbide (WC–Co) hardmetal is known for its high hardness and wear resistance in various applications. Micro-PIM is a new alternative manufacturing technique for hardmetal micro-parts. In this work, the fabrication of WC–Co components via a micro-PIM process was studied. A fine WC–10Co–0.8VC (wt.%) powder was mixed with a binder system consisting of paraffin wax, low density polyethylene and stearic acid. A micro-component was injected at low pressure using a semi-automatic injection moulding machine. The injection temperature was determined from the rheological investigation of the feedstock. The binder extraction was carried out in solvent and thermal debinding methods under an argon atmosphere. Thermal gravimetric analysis was used to confirm the removal of the soluble binder from the green part. The sintering process has been performed within a temperature range of 1330–1450°C under vacuum. After sintering, a density of 94.5% theoretical density was obtained, which is a reasonable value. The micro-components showed length shrinkage between 16 and 22% and good surface quality and hardness values when compared with conventional powder metallurgy. This research shows that micro-PIM is able to produce small WC–Co components with properties comparable to conventional powder metallurgy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
