Fabrication and characterization of large-size electrolyte/anode bilayer structures for low-temperature solid oxide fuel cell stack based on gadolinia-doped ceria electrolyte

Abstract

Preliminary progress is reported in this communication in building a planar anode-supported low-temperature solid oxide fuel cell (SOFC) stack based on gadolinia-doped ceria (GDC) electrolyte, i.e. fabrication and characterization of a Ø80 planar bilayer structure composed of GDC electrolyte film and Ni–GDC anode substrate. The anode substrates were prepared from mixtures of NiO, GDC, and carbon black by die-pressing. After pre-firing to remove the carbon black, the anode substrates were deposited with a GDC layer using a spray coating technique. The green bilayers of anode substrate and electrolyte film were then co-sintered at 1500 °C for 3 h. Through proper control of the sintering process, bilayer structures with excellent flatness were achieved after co-sintering. Scanning electron microscopy (SEM) observation indicated that the electrolyte film was about 22 μm in thickness, highly dense, crack-free, and well-bonded to the anode substrate. Small disks which were cut out from the Ø80 bilayer structure were electrochemically examined in a single button-cell mode incorporating a (LaSr)(CoFe)O 3–GDC composite cathode. With humidified hydrogen as the fuel and air as the oxidant, the cell demonstrated an open-circuit voltage of 0.884 V and a maximum power density of 562 mW/cm 2 at 600 °C. The results imply that high-quality anode-supported electrolyte/anode bilayer structures were successfully fabricated. Based on them, planar anode-supported SOFC stacks will be assembled in the future.