Fabrication and assessment of partial finger prostheses made using 3D-printed molds: A case study.

Abstract

3D printing for custom prosthetic finger fabrication can have better fit and comfort than non-custom off-the-shelf ones while reducing fabrication labor time. The purpose of this case study was (1) to design and fabricate custom prosthetic fingers using 3D-printed molds for the treatment of partial finger amputation; (2) to evaluate patient satisfaction of the custom prosthetic fingers fabricated using 3D-printed molds and compare them to the custom prosthetic fingers fabricated through a conventional method of molding using plaster casts. The method to develop the custom prosthetic finger are as follows: (1) The shapes of the residual digits and contralateral fingers were acquired using a high-resolution 3D optical scanner. (2) Prosthetic fingers were designed by modifying the model of the residual digits and the contralateral fingers. (3) Molds of the prosthetic fingers were designed using computer-aided design software and fabricated by 3D printing. The study compared hand function tests and rehabilitation outcome surveys to evaluate the performance of the prosthetic fingers fabricated using 3D-printed molds and plaster casts. This case suggests that the prosthetic fingers fabricated using 3D-printed molds had comparable performance to the prosthetic fingers fabricated using plaster casts. The aesthetics and transparency of the prosthetic fingers contributed highly to the low satisfaction of the prosthetic fingers fabricated using 3D-printed molds.