Abstract

Strong ground motions from the 2016 Mw 7.0 Kumamoto earthquake (Japan) can be well simulated based on a characterized source model consisting of strong-motion generation areas (SMGAs) with high stress drop and a background area with low stress drop, except at very near-fault stations (Irikura et al. in Earth Planets Sp 69:10, 2017). Strong ground motions observed at very near-fault stations less than 3 km away from the surface traces along the Futagawa fault zone have long-period motions including maximum permanent displacements beyond 2 m. To reproduce such long-period ground motions at those very near-fault stations, one must place SMGAs in the seismogenic zone but also add long-period-motion generation areas (LMGAs) in the weak shallow layer (SL) zone between the top of the seismogenic zone and the free surface. During the 2010 Mw 7.0 Darfield (New Zealand) earthquake, surface breaks caused by the mainshock were found associated with active faults by field surveys. Strong ground motions from the 2010 Darfield earthquake can also be simulated well using the conventional characterized source model, except for ground motions at very near-fault stations. Reproduction of very near-fault motions with permanent components for the 2010 Darfield earthquake also requires consideration of LMGAs in the SL zone. We thus propose an extension of the characterized source model by adding LMGAs in the SL zone. The parameters for the SMGAs are given following the recipe of Irikura and Miyake (Pure Appl Geophys 168:85–104, 2011), while the parameters of the LMGAs are estimated from two scaling relationships, viz. the surface displacement versus the average slip in the rupture area from the source inversion, and the surface displacement versus the rise time of the slip velocity time function in the LMGA from the forward simulation.

Highlights

  • Strong ground motions are more closely related to regions of slip heterogeneity rather than the entire rupture area or total seismic moment (Irikura and Miyake 2011)

  • For the 2016 Mw 7.0 Kumamoto earthquake, surface breaks caused by the mainshock were found associated with the Futagawa-Hinagu fault system by field surveys

  • For the 2016 Mw 7.0 Kumamoto earthquake, surface breaks caused by the mainshock were found associated with the Futagawa–Hinagu fault system by field surveys

Read more

Summary

Introduction

Strong ground motions are more closely related to regions of slip heterogeneity rather than the entire rupture area or total seismic moment (Irikura and Miyake 2011). One of the problems in reproducing strong ground motions from the 2016 Kumamoto earthquake is that observed long-period motions with permanent displacements at the very near-fault stations are not well simulated based on the conventional characterized source model. To generate such long-period motions near fault traces, long-period-motion generation areas (LMGAs) located in a weak shallow layer (SL) zone defined as part of the crust between the top of the seismogenic zone and the free surface (Dalguer et al 2019) must be taken into account. Displacements at ROLC are small: 69 cm in horizontal EW and 41 cm in vertical

Simulation of Near-Fault Ground Motions Using Characterized Source Model
Characterized Source Model of 2016 Kumamoto Earthquake
Characterized Source Model of 2010 Darfield Earthquake
Extension of Characterized Source Model
Conclusions

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.