Abstract
Powder lubrication has been studied using a plane contact tribometer. Four kinds of powders—polytetrafluoroethylene (PTFE), graphite, MoS2, and ball-like copper—were used during the experiments. The results show that powder can be introduced into frictional clearance without any special treatment. The powder's physical properties significantly influence the tribological characteristics in the powder lubrication. The friction coefficient and wear are obviously decreased when the powders are PTFE, graphite, and MoS2, which are excellent solid lubricants. At lower load capacity, powder lubrication using ball-like copper had certain antifriction effects, but it rapidly became worse with increasing load capacity. Observation with optical microscopy showed that the lubricant film is dynamically formed on the rubbing surfaces in most experiments.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
