Experimental Study of Shear Behavior of Rock Joints under Two Types of Boundary Conditions: Constant Normal Load and Constant Normal Stiffness

Abstract

Shear destruction of rock mass along weakened planes is one of the main reasons of the failure of career boards, underground workings and rock slopes. The paper deals with laboratory testing of rock joints under direct shear loading. Special test and measurement complex was created to study deformation and strength characteristics of rock joints. Test specimens were made from single slab of sandstone of homogeneous structure. Shear tests have been conducted under constant normal load (CNL) and constant normal stiffness (CNS) boundary conditions at three values of normal compressive stress: 0.5 MPa, 1.2 MPa and 1.8 MPa. The analysis of test results allowed to reveal patterns of changes of deformation-strength properties of rock joints depending on the level of normal load, boundary conditions and roughness values. The ultimate shear stress is always higher under CNS boundary condition than CNL for the same values of normal compressive stress. Shear stress practically retains constant value after reaching the ultimate stress under CNL boundary conditions and it decreases under CNS conditions. The values of ultimate shear stresses, shear modulus and the length of linear section on “shear stress–shear displacement” curve increases with increasing surface roughness at the equal levels of normal compressive stress.