Experimental study of phase transition heat of composite thermal energy storage materials paraffin wax/expanded graphite

Abstract

In this paper, the effect of the expanded graphite (EG) matrix on the phase transitions enthalpy of phase change material (PCM) is studied experimentally. For this purpose, the paraffin wax (PW) containing EG (up to 6.5 wt%) was explored in terms of the effective heat capacity and a diffuse phase transitions enthalpy difference over the 25–65 °С temperature range. Composite PCMs PW/EG was prepared using a new method and were inherent in high pores fill factor. The main advantage of the proposed method is preliminary vacuuming of the PW and EG with subsequent mixing and sonication under vacuum. The EG choice was based on the hypothesis that the EG matrix contributes to modifying the PW internal structure due to the PW molecules' adsorption on the EG surface during PCM cooling and solidification. Consequently, a significant change in PW/EG caloric properties vs. pure PW was observed. The EG presence in PW reverses the enthalpy hysteresis in the heating-cooling cycle vs. pure PW. The enthalpy difference during PW heating and melting in the range of 30–60 °С is higher than during its cooling and solidification: 336.2 J∙g−1 vs. 214.9 J∙g−1. On the contrary, the enthalpy difference of melting for PW/EG of 3.6 wt% in the range 30–60 °С was 171.2 J∙g−1 vs. 273.8 J∙g−1 during solidification. The obtained results are explained by the different dynamics of processes of PW melting and solidification in EG matrix pores. The presence of the 3.2–6.5 wt% of EG in PW contributes to an increase in solidification enthalpy difference in the range 30–60 °C on 27–33 % vs. pure PW. A decrease in the melting enthalpy difference for PW/EG on 44–50 % vs. pure PW was recorded in the range of 30–60 °C. In addition, thermal conductivity was measured to confirm the advantages of PW/EG as PCM. Thermal conductivity for PW/EG with EG content of 3.6 and 6.5 wt% at 25 °C was 8.9 and 9.6 times higher than for pure PW. Similarly, 8.8 and 10.9 times thermal conductivity increase was observed at 65 °C. The composite PCM containing 3.6 wt% of EG in PW obtained by developed method can be recommended as a rational composition in benefit of the thermal conductivity and caloric properties for utilization in high-performance TES systems.