Experimental Study of Large Area Suspended Ceilings

Abstract

ABSTRACTDamage of nonstructural components during past seismic events was shown to be not only a critical threat to life safety in extreme cases but also led to substantial reduction of functionality of buildings and other facilities. Because of the complex construction of nonstructural and architectural components, current standards provide only limited guidance for the seismic design. Suspended ceiling systems are among the less understood important nonstructural/architectural components in buildings for which design standards provide limited guidance. To understand the dynamic behavior of suspended ceiling systems, a series of full scale shake table tests of 20 ft × 53 ft and 20 ft × 20 ft ceiling systems were conducted at the Structural Engineering and Earthquake Simulation laboratory (SEESL) at University at Buffalo (UB). For the full scale dynamic testing, a new test frame providing a continuous suspended ceiling area of 1,060 ft2 was constructed on the tandem shake tables and was equipped with an open-loop shake table compensation procedure. The combined designs of the physical frame and of the shake table motion controllers allowed simulating the required floor/roof motion according to ICC-ES AC156 standard at the roof of the test structure. Various test configurations were selected in order to determine the influence of different system conditions and the effects or efficiency of various protective systems required by the current standard ASTM E580 for seismic design. Based on the test data and the failure mechanisms observed, damage states are defined, and fragility curves are developed. The results of the fragility analysis show that a ceiling system becomes more vulnerable as (a) it is subjected to multi-directional input motions, (b) heavier tiles are installed, (c) the size of a ceiling area increases, and (d) lateral restraints are not installed. In addition, simplified numerical models that can capture the special behavior of ceiling systems are developed and presented in a companion paper. This paper presents the experimental study of large area suspended ceiling systems involving test setup and configurations, test motions generated by a unique control system, and basic lessons gained from the experiments.