Experimental studies on the flow velocity of molten metals in a ladle model at centric gas blowing

Abstract

Experimental measurements of the flow velocity were carried out with liquid Wood's metal in a ladle‐shaped vessel with an inner diameter of 40 cm at centric gas blowing. By means of permanent magnet probes the liquid flow field was measured under various blowing conditions. The results show that a circulating flow field is established in the vessel. In the bubble plume zone an upwardly directed liquid flow is formed. The radial distribution of the flow velocity in this zone follows a Gaussian function. The axial flow velocity increases with growing gas flow rate and is nearly constant in vertical direction. The width of the upward flow becomes larger with increasing distance from the nozzle and its dependence from the gas flow rate is not considerable. At centric gas blowing the liquid in the upper part of the bath streams quickly, whereas in the lower part so‐called “dead zones” with very low flow velocity are present.Besides the time‐averaged value of the flow velocity, the turbulent behaviours of the liquid flow such as fluctuation velocity, the turbulent kinetic energy and its dissipation rate were investigated on the basis of measured data. It was found that the liquid flow is turbulent particularly in the region of bubble plume and of bath surface. The radial profiles of these parameters can also be described by a Gaussian function. Only a small part of the gas stirring energy is changed into the kinetic energy of the directed liquid flow. Most of the stirring energy is already dissipated in the bubble plume zone.