Abstract
Pyroelectric detectors are widely used for infrared radiation detection, whereas these can also be used in the X-ray region. They have multiple advantages when used at synchrotron radiation sources, such as (a) can be used with a white beam (high flux), (b) have a flat spectral response, and (c) can be used both as a detector and as a sample. However, when used in the hard X-ray region, absorption in the detector plays an important role depending upon the thickness of the detector. Hence, the estimation of the responsivity of the detector is important. In this paper, we report an improved experimental setup for the measurement of a pyroelectric signal in the hard X-ray region. The responsivity (V/W) of a pyroelectric detector for absorbed radiation in the hard x-ray region is measured. Measurements of the K-edge x-ray absorption fine structure of 10-μm copper and nickel foils are carried out using a LiTaO3 pyroelectric detector and compared with the measurements carried out using an ionization chamber as a sensor for the same foils. Absorption spectra near the Ta LIII and LII edges in LiTaO3, measured using a LiTaO3 crystal both as a sample and as a sensor, are also reported in this paper.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call