Abstract
Widely-used methods for characterising the fibre/matrix interface in polymeric composites are the fragmentation test and the droplet test as a special kind of the single-fibre pull-out test. A severe disadvantage of these tests is that non-realistic model samples are investigated which contain only one fibre in the matrix. In order to obtain data about the effect of the different residual stress situations for fibres in such samples and in composites, pull-out tests of E-glass fibres in polystyrene and polycarbonate are performed using samples, where the investigated fibre is surrounded by 0 to 3 other near fibres. Neighbouring fibres can increase the pull-out forces by a factor of three and the interfacial toughness by a factor of four. This has to be taken into account, if the tests are performed not only for comparison reasons but for measuring interface properties.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
